Similar to re-personalizing the settings as seen above, this method will force a new file to be written. You will see a dialog pop up, about personalizing your user settings. Hold Shift + Control while opening Cakewalk by BandLab (or SONAR). If you’re not using an audio interface, you may want to try: Solution: Ensure your program is up to date, then install the latest available drivers from the manufacturer. This should push the program to finish opening! Quick test: If you’re using an audio interface, disconnect it while the splash screen is hanging. Additionally, if the program didn’t let go of the driver when closing, or if the driver is in use by another program, a hang at the splash screen may exist. This can be caused by the program trying to connect to a bad driver. To avoid conflict between software and hardware, make sure Cakewalk by BandLab is updated, then get the latest available drivers from the manufacturer. This will allow you to disable any or all plugins, and remove or replace them as necessary.Īudio driver errors can affect opening a project as well as closing Cakewalk by BandLab. Solution: Open your project in Safe Mode by holding Shift while opening the project. While most VST2 and VST3 plugins work without issue in CbB, there can be varied results which may result in hanging, crashes, etc, while loading the project. Older projects that used more 32 bit plugins may be troublesome, as Cakewalk by BandLab is 64 bit. If there are plugins saved within the project that no longer exist on the machine, you should be able to open the project but will receive a warning that the plugins are missing. Plugins are the primary cause for trouble opening a project. If you’re having trouble opening a project, there are a few things to consider. Cakewalk by BandLab can open Cakewalk Project Files (.cwp), Cakewalk Bundle Files (.bun), and even pre-SONAR files in the.
0 Comments
Leave a Reply. |